Care Peptides guide
Mass Spectrometry for Peptides: Confirming You Have the Right Molecule
HPLC tells you how clean a sample is. Mass spectrometry tells you what it is. This guide explains how to read the mass-spec section of a peptide certificate, including the charge-state numbers that confuse most people.
Published by Care Peptides on 11 Jul 2026 · Last reviewed 5 Nov 2026
Quick answer
A mass spectrometer measures the mass-to-charge ratio (m/z) of ionised molecules. On a COA you should see the peptide's expected molecular weight next to the observed value, and they should match closely. If the spectrum shows peaks at about half or a third of the molecular weight, that's normal: they're the same molecule carrying two or three charges.
Key takeaways
- It confirms identity: Matching mass is strong evidence the right peptide was made.
- Charge states are normal: One peptide can produce several peaks at different m/z values.
- It's not a purity test: Use HPLC for purity. Mass spec answers a different question.
How it works, briefly
The sample is turned into charged ions, usually by electrospray ionisation (ESI) or MALDI. The instrument then sorts the ions by mass-to-charge ratio and counts them. The result is a spectrum: m/z along the bottom, signal strength up the side.
Understanding charge states
With ESI, peptides often pick up more than one proton, so the same molecule appears at several m/z values. For a peptide with molecular weight M carrying n extra protons, the peak appears at roughly (M + n × 1.007) ÷ n.
Example: BPC-157 has a molecular weight of about 1419.5 Da. You'd expect to see it near m/z 1420.5 as [M+H]+ and near m/z 710.8 as [M+2H]2+. Both peaks point to the same molecule. MALDI spectra tend to show mainly the singly charged [M+H]+ ion.
Expected vs observed mass
A COA should state both. Small differences are normal and depend on the instrument: high-resolution instruments agree to within a few parts per million, while routine ones are often within about ±1 Da for a peptide this size. Also note whether the figure is the monoisotopic mass (lightest isotopes only) or the average mass. They differ by around 1 Da for mid-size peptides, which can look like a mismatch when it isn't.
What mass spec can't tell you
- How much impurity there is. Peak heights aren't a reliable purity measure.
- Molecules with the same mass. Some sequence errors or isomers weigh exactly the same.
- Water and salt content.
That's why a complete COA pairs mass spec with HPLC purity.
Red flags in the mass-spec section
- An “MS: conforms” line with no numbers and no spectrum.
- No expected mass stated, so there's nothing to compare against.
- Observed mass that's far off and not explained by charge state or isotope type.
- A spectrum with unlabelled axes or no batch number.
Frequently asked questions
Why does my COA show a peak at half the molecular weight?
That's the doubly charged ion [M+2H]2+. The molecule's mass is divided by its charge, so it appears at roughly half the m/z. It's the same peptide.
How close should observed and expected mass be?
Within the accuracy of the instrument. That's often within about 1 Da on routine equipment, and much closer on high-resolution systems. Check whether both figures use the same mass type (monoisotopic or average).
Can mass spec replace HPLC?
No. Mass spec confirms identity; HPLC measures purity. A good COA includes both.
Related product specifications
Keep reading
Ready to order?
Find your exact SKU in the catalog, check the COA where one is linked, and send your list to Kyle on WhatsApp.
Sources and review references
These references support the analytical terminology and documentation-review framework used in this guide. How we check our listings.